⎝⎛优德w88体育网⎞⎠

Unfortunately, because your browser version is too low to get the best browsing experience, it is recommended to download and install Google Chrome!

Temperature and humidity sensor makes the dust-free workshop clean and bright—— 【鑫 芯 物 联】

来自: 成都鑫芯电子科技有限公司 浏览次数:2198 2015-11-09From : Chengdu Xinxin Electronic Technology Co., Ltd.

In the production of electronic components or some important links in the production of chemical products, most production workshops require moderate temperature and humidity , clean and dust-free. Only in a suitable temperature and humidity and clean environment, the parameters of these electronic components The performance can reach the required standards, and the chemical products will not have abnormal reactions due to the environment.

Dust-free workshops for electronic components require moderate temperature and humidity. High temperature and high humidity will cause component performance to fluctuate, low temperature and low humidity will cause air to dry, and it is easy to generate static electricity and cause short circuits between devices. 温湿度传感器 来进行温度和湿度的监测,结合控制系统,一般采用空调、加湿机、除湿机来调节温湿度,而且系统可以人为的设置控制的温湿度值上下限,这就不会导致由于温湿度过量的控制而导致环境温湿度异常。 Therefore, in the clean room, temperature and humidity sensors are needed to monitor the temperature and humidity. In combination with the control system, air conditioners, humidifiers, and dehumidifiers are generally used to adjust the temperature and humidity, and the system can manually set the upper and lower limits of the temperature and humidity control. It will not cause abnormal temperature and humidity of the environment due to excessive temperature and humidity control. Before entering the dust-free workshop, workers will perform a certain treatment to remove the dust and static electricity attached to the person, and try to keep them in a dust-free and static-free state. An air circulation purification system will also be installed in the workshop to filter the dust for 24 hours. If there is more dust in the workshop, use a dust collector for treatment.

The requirements of chemical plants and electronic components cleanrooms are basically the same, but this is only for the special chemical industry. However, no matter what the temperature and humidity requirements, Xinxin IoT temperature and humidity sensor and temperature and humidity monitoring system can well determine the development of monitoring equipment and software systems for special environmental requirements.

Xinxin IoT temperature and humidity sensor has a measurement range of temperature -20 ℃ ~ 85 ℃ and humidity 0% RH ~ 100% RH, which can be applied to many occasions where temperature and humidity sensor monitoring and temperature and humidity control are required.


November 9, 2015

Chengdu Xinxin Electronic Technology Co., Ltd. Editorial Department

Editor: Little Devil in Gourd

天天电玩城 七乐彩 欢乐拼三张 星力捕鱼